z-wave

The last version 1.6 of openzwave is from 2019.
Therefore, I moved to Zwavejs2Mqtt.

zwave2mqttjs

To have a z-wave master, I installed Zwavejs2Mqtt.

sudo apt-get update
sudo apt-get upgrade --fix-missing

1. wavejs2mqtt-snap-package

   sudo apt update
   sudo apt install snapd
   sudo reboot
   sudo snap install core
   sudo snap install snapd
   sudo snap install zwavejs2mqtt
   You will find it in /snap/zwavejs2mqtt/

2. Set some access configuration:
   sudo snap connect zwavejs2mqtt:raw-usb
   sudo snap connect zwavejs2mqtt:hardware-observe
   

   ---

   sudo snap set system experimental.hotplug=true
   sudo systemctl restart snapd
   snap interface serial-port
   sudo snap connect zwavejs2mqtt:serial-port
   

   ---

   sudo snap set zwavejs2mqtt server.host="0.0.0.0"
   sudo snap set zwavejs2mqtt server.port=8091
   
3. Check whether everything runs fine:
   sudo run zwavejs2mqtt.exec
   

   I had to encounter:
   cannot mount bpf filesystem under /sys/fs/bpf: No such file or directory.
   
   

   sudo snap restart zwavejs2mqtt
   Show GUI in a browser:
   dillo http://localhost:8091
   
4. Finaly create a deamon:
   sudo zwavejs2mqtt.daemonize
   And watch the log:
   sudo snap logs zwavejs2mqtt -f

z-wave USB Stick UZB

Plug your UZB into the USB slot. It will light up shortly, and then it stais sleeping, until you"ll use it.

For connection find its ID by:
ls /dev/serial/by-id/

usb-0658_0200_12345678-9012-3456-7890-123456789012-if00

Remote Control ZME_KFOB_S

I had major problems to include the KFOB remote control -- and that was mainly due to timing issues:

• To enter Management Mode, I have press all 4 buttons 10 sec -> LED blinks green slowly.
• To reset the device, I have to press button 3 shortly and then hold button 4 for 10 sec ! Watch for the LED reaction.
• To include into network, enter Management Mode again and press button 1 -> LED blinks green/red alternating.

Roller Shutter FIB_FGRM-222

FIBARO Roller Shutter 2